Hioki PW3198 Power Quality Analyzer

The 3198 can measure all waveforms of power, harmonic, and error events simultaneously. When a problem occurs with the equipment or system on your site, the 3198 will help you detect the cause of the problem early and solve it quickly. You can depend on the 3198 to monitor all aspects of your power supplies.

The 3198 can simultaneously record 8,000 or more parameters, such as voltage, current, power, power factor, frequency, integral power, harmonic, and flicker, at the specified recording interval. The 3198 never fails to capture the peak because it performs calculations continuously and records the maximum, minimum, and average values within the recording interval.

All Optional 3198 Power Quality Kits Include:
-3198 Power Quality Analyzer
-L1000 Voltage Cable Set
-Hard Carrying Case
-AC Adapter
-Rechargeable Battery Pack
-9624-50 PQA HiView Pro Software
-Z4001 2GB SD Card

Note: Voltage can be measured with the main unit alone. An optional current sensor is necessary to measure current or power parameters. Use Model 9624-50 PQA-HiVIEW PRO (version 2.00 or later) with a PC to analyze the data collected to the SD card. 

• Verify power problems in accordance with the IEC61000-4-30 Class A standard
• High Accuracy and continuous gapless recording (V:±0.1% of nominal voltage, A and W:±0.2% rdg. ±0.1% f.s.)
• CAT IV 600V – safe enough for incoming power lines
• Broadband voltage range lets you measure even high-order harmonic components of up to 80 kHz
• Wide dynamic range from low voltages up to 1300V (3P4W line-to-line voltage)
• Maximum 6000V transient overvoltage up to 700kHz
• LAN, USB and SD card interfaces
• Optional GPS BOX for synchronizing multiple devices
• Measurement items:
  1. Transient overvoltage : 2MHz sampling.
  2. Frequency cycle : Calculated as one cycle, 40 to 70Hz
  3. RMS voltage/ RMS current refreshed each half-cycle
  4. Voltage swell, Voltage dips, Voltage interruption
  5. Inrush current
  6. Voltage waveform comparison
  7. Instantaneous flicker value: As per IEC61000-4-15
  8. Frequency: Calculated as 10 or 12 cycles, 40 to 70Hz
  9. 10-sec frequency: Calculated as the whole-cycle time during the specified 10s period, 40 to 70Hz
  10. Voltage waveform peak, Current waveform peak
  11. Voltage, Current, Active power, Apparent power, Reactive power, Active energy, Reactive energy, Power factor, Displacement power factor, Voltage unbalance factor, Current unbalance factor (negative-phase, zero-phase)
  12. High-order harmonic component (voltage/ current): 2kHz to 80kHz
  13. Harmonic/ Harmonic phase angle (voltage/ current), Harmonic power: 0th to 50th oders
  14. Harmonic voltage-current phase angle: 1th to 50th orders
  15. Total harmonic distortion factor (voltage/ current)
  16. Inter harmonic (voltage/ current): 0.5Hz to 49.5Hz
  17. K Factor (multiplication factor)
  18. IEC Flicker, Δ V10 Flicker

  Note: Voltage can be measured with the main unit alone. An optional current sensor is necessary to measure current or power parameters. Use Model 9624-50 PQA-HiVIEW PRO (version 2.00 or later) with a PC to analyze the data collected to the SD card.

• Hioki PW3198 Datasheet